Task Description Status Comments
Translate Software
Translate CAD (Manual)
Load BOM (Manual)
Auto-assign component type
Complete BOM information (Manual)
Skip TH Components
Assign Probes (Manual)
Assign Toolings (Manual)
Modify origin to match drawing (Manual)
Export Board / Board XY
Board / Board XY
Check Board
Check Board XY
Assign Board Heading
Assign AutoFile
WireWrapping to AUTO
Generate Panelization
Assign Toolings
Adjust Limits
Enable Large Capacitor DC Mode (Capacitors > 10μF
Move resistors < 10Ω and inductors < 1mH to Jumper
Check config
Compile config
Assign Node GND
Create Power Derivation Table
Assign Fixed Nodes
Assign Power Nodes
Mark Test Points as Mandatory / Drilled
Enable / Disable Top Probes
Verify Power / GND Node Count
Programming: Mark nodes as critical
Boundary Scan (Manual)
Enable ground Bounce Suppression and Boundary Scan Disables (if BS is used)
TestJets
Polarity
Assign Libraries
Generate Safeguards
Switch Probes
Add Pressence Tests
Generate Power Check Test
Generate "bus_res_tests"
Move components with TestJet or Polarity to the same side
Add Versions
Select Fixture Type
Compile Libraries
Check Board
Compile Board
Check BoardXY
Compile BoardXY
Fixture
Fixture Consultant
List Fixture
Relocate Panel
Verify Fixture
Keepouts
Compile Fixture
Probe Selection
IPG
Reduce Config
Compile Config
Run IPG
Last Steps
Add Cluster Tests
Add Cover and Presence Tests
Add Marker Test (if apply)
Fill BRC´s
Verify Blocked Pins
Add Discharge Resistors
Enable Test Commented by IPG
Generate Info Folder
Apply Standard Limits
Clean Directory